Tag Archives: hall table

My Final Project from woodworking school- finally revealed!

27 Jan

I thought now would be a good time to show you my Final Project from woodworking school. I worked for 11 months with very little creative freedom. Most of our projects had strict parameters.

Well not so with the last month of the woodworking course, I had the option of building from existing plans or going for an original design. I chose the latter. I was busting to finally have shop time to create something I could be proud of and had complete creative freedom over! In class we had recently learnt how to use Google SketchUp (a free designing utility) and so I was off to the races. Here’s my attempt at rendering my design on SketchUp:

Don't mind those side panels, I couldn't scale them up properly.

And here it is in reality:

Hall Table / Laptop Desk

It's a hall table, but can also be a laptop desk. I made sure it would also fit behind a standard couch. It's made out of maple and walnut.

I finished it with lacquer, and luckily had access to the spray booths and equipment at school.

And now for the details:

I added butterfly joints for design reasons, but they're still inlaid 1/4" deep! I'll get a wax stick for that little imperfection- no worries!

These are not plugged screws. I ran dados in the legs to hold the shelf up securely, then used a dowelling jig to insert 2" long walnut dowels through the leg to the shelf. Each leg attaches to a walnut apron above with two vertical dowels.

The walnut apron is topped with a sliding dovetail that was slid into the underside of the table top. The apron is pegged in the middle to the top. I plugged the overhang portion of the slot and left a 1/8" space between the plug and the slide for wood movement.

For the back panel I cut mortises into both the back rail and the underside of the shelf, each tenon has 1/8" on either side of it inside the mortises to allow for wood movement. To keep the panel in place as this is a dry joint I pegged the tenons and glued those pegs in.

There are through tenons that pass through the legs into the side rails. They're solid walnut.

The drawer simply rides against a guide which is screwed into the top with elongated holes. The guides fit into dados made into the top.

Both heron panels were cut stuck together on the scroll saw. I ran stopped grooves(at different heights) along the insides of each leg to fit the panels.

The drawers were made with a simple locking joint. I wedged a dowel into the underside of the table top to act as a drawer stop.

Last but not least I designed the table to look appealing from all angles in case the owner didn't keep it butted against a wall.

And this completes the tour of my final project. Hope you enjoyed it!

I plan to post photos of my Vernissage soon, to share with you all of the final projects from my class.

Stay tuned!

%d bloggers like this: